Designing and Calibration of the System for Remote Strain Control

Designing and Calibration of the System for Remote Strain Control

Abstract:

Strain measurements by strain gauges is the most common method. In this paper is shown complete development process of a device, which measures the strain and sends the measured values over the Internet. Measuring device is proved with some known strain values. After the confirmed accuracy it is installed on remote construction, which is being monitored 24 hours per day. To prove the accuracy of the results, FEM analysis of the remote construction is done. Both solutions show very good overlap.
Published in: 2018 International Conference on Smart Systems and Technologies (SST)
Date of Conference: 10-12 Oct. 2018
Date Added to IEEE Xplore: 06 December 2018
ISBN Information:
INSPEC Accession Number: 18323375
DOI: 10.1109/SST.2018.8564706
Publisher: IEEE
Conference Location: Osijek, Croatia

 

Mechanical Engineering Faculty in Slavonski Brod, Slavonski Brod, Croatia
Josip Juraj Strossmayer University of Osijek, Osijek, Croatia
Construo-mat Smartematiks, Slavonski Brod, Croatia
Construo-mat Smartematiks, Slavonski Brod, Croatia

References

 

References is not available for this document.

IEEE Personal Account

https://ieeexplore.ieee.org/document/8564706